1. All employees should check whether their clothes meet the work requirements before entering the work post. Do not wear slippers, high heels and unsafe clothing, long hair to wear a helmet. Maintain the CORRECT posture when working, to have enough spirit to cope with the work, if found physical discomfort will immediately leave the work post, and report to the leader. During operation, we must concentrate on the mind, do not gossip, cooperate with each other, the operator must not be agitated, tired state of operation, so as to avoid accidents, to ensure the safety of operation.

2. Check whether the moving part is filled with lubricating oil before the mechanical work, then start and check whether the clutch and brake are normal, and run the machine empty for 1-3 minutes. It is strictly prohibited to operate when the mechanical fault occurs.

3. When replacing the mold, first turn off the power supply, and the press movement department can stop running before the installation and debugging of the mold can be started. After the installation and adjustment, move the flywheel by hand for two times to check whether the upper and lower molds are symmetrical and reasonable, whether the screws are strong, and whether the blank holder is in a reasonable position.

4, must wait for other personnel to leave the mechanical work area, and take away the sundries on the workbench, can start the power to start the machine.

5. After the machinery is started, one person shall carry materials and operate the machinery. Other people shall not press the electrical construction or step on the pedal switch board, nor shall they put their hands into the mechanical work area or touch the moving part of the machinery with their hands. When the machine is working, it is forbidden to reach into the slider work area, and it is forbidden to take and release the work piece by hand. Standard tools must be used when taking and releasing parts in the die. If the machine has abnormal sound or machine failure, should immediately turn off the power switch for inspection.

6. Turn off the idle power supply when off work, and sort out the finished products, edge materials and sundries on the post to ensure the clean and safe working environment.

The above operating procedures must be consciously observed, do not violate the rules of operation, failure, should cooperate with maintenance personnel maintenance, accident immediately cut off the power, keep the site report to the factory to wait for processing, all the consequences caused by the violation of operating procedures, by the parties to bear all the consequences.